Orings Failure Analysis Guide

Among the most common reasons for O-Ring failure is either incorrect groove design or improper selection of compound. By correctly identifying the reason for failure, necessary changes can be made to tend design or material and eventually lead to improved seal performance. Analyzing the cause of failure and going to the root of every problem is extremely crucial in assuring efficient seal functionality and safety. As you can see below, we have listed down some common O-Ring Failures; the observations and causes for the same. Understanding the causes behind the failures, serves as a precautionary set of measures that should be observed in the given conditions.

Failure Description

Reason For Failure

Dimentional defect

• Non performance of o-ring.

• No visual defects

• Inaccurate groove/gland design.

• Incorrect o-ring dimensions

• Misalignment of mating surfaces

Compression Set

• Visible flattened cross section

• Incomplete curing of elastomer before installation

• Excessive compression

• Chemical incompatibility

• Excessive temperature

Molding damage

• Flattened surface, corresponding to the mating surfaces, with some cracks

• Failure to account for thermal/chemical expansion during molding

• Excessive compression

Explosive Decompression

• Blisters and pits visible on the seal surface.

• Absorption of gas at high pressures, and then immeditae decrease in pressure

• The absorbed gas ruptures the seal surface when the pressure is rapidly reduced.

• Rapid pressure chages during molding operation

• Low hardness of elastomer

Shrinkage defect

• This failure cannot be detected on visul inspection of the o-ring.

• There is a shrinkage in the cross sectional size of the seal.

• Improper curing of elastomer.

• Low hardness of elastomer

• High vaccuum pressure

Installation damage

• Cuts and incisions visible on the o-ring body.

• Sharp edges on the installation eqiupment Inaccuate sizing of the elastomer

• Low hardness of elastomer

Abrasion damage

• Flattening of the o-ring on one side. Loose particles or scrapes may be found on the seal surface. This failue is usually found in dynamic seals

• Improper/rough finish of the sealing surfaces.

• Excessive temperatures

• System contamination ny abrasive particles

Extrison and nibbling defects

• Ruptured edges visible on the low pressure side of the o-ring.

• Excessive clearnaces

• Irregular clearance gaps

• O-ring material could be too soft

• High pressure between mating surfaces

• Degardation (swelling, cracking, shrinking, etc.) of o-ring material due to system fluid

Spiral Cuts

• Deep spiral cuts appear on the surface of the o-ring (around the circumference)

• Tight installation of the o-ring

• Slow stroke speed

• Inadequate lubrication

• Low elastomer hardness

• Uneven surafce finish

Thermal degradation

• The o-ring develops cracks. The elastomer might begin to soften and develop a shiny surface

• Excessive temperatures

• Incompetent thermal properties of the elastomer

Let us guide you. Speak to one of our experts

+91 9130026591

Know exactly what you want? Upload your drawings so we can provide a tailored solution

Get in touch with us today by email sales@westernrubbers.com